From Friday, April 19th (11:00 PM CDT) through Saturday, April 20th (2:00 PM CDT), 2024, ni.com will undergo system upgrades that may result in temporary service interruption.

We appreciate your patience as we improve our online experience.

Home Community Discussion Forums Most Active Software Boards NI TestStand Topic

NI TestStand

cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 

TestStand, DIO and MAX

TestStand, DIO and MAX

‎04-28-2016 02:26 PM

I can go to Measurement and Automation Explorer and select my NI USB-6501 Test Panel, select the correct port and line depress the Start button and my relay closes.  See attached example.  Is there a way in TestStand to close the same relay without relying on a custom step type?  Can you point me to where I could execute this operation in TestStand.  Thanks.

 

Tony

0 Kudos
Message 1 of 2
(3,066 Views)
Reply

Re: TestStand, DIO and MAX

‎04-29-2016 12:58 AM

Hey Tony,

 

You could use an IVI step to perform your switching.

 

http://www.ni.com/white-paper/10092/en/

 

Oli

0 Kudos
Message 2 of 2
(3,038 Views)
Reply