NI TestStand

Showing results for 
Search instead for 
Did you mean: 

TestStand, DIO and MAX

I can go to Measurement and Automation Explorer and select my NI USB-6501 Test Panel, select the correct port and line depress the Start button and my relay closes.  See attached example.  Is there a way in TestStand to close the same relay without relying on a custom step type?  Can you point me to where I could execute this operation in TestStand.  Thanks.



0 Kudos
Message 1 of 2

Hey Tony,


You could use an IVI step to perform your switching.



Thanks for supporting the GLA Summit 2021!

GLA Summit 2021
0 Kudos
Message 2 of 2