Measurement report including limits and comparison type LT/LE

[markus kossmann]

If I choose "include limits" in report options and the numerical limit teststep uses LE or LT as comparison type Teststand uses Step.Limits.Low as property for the that single limit. But logically this is a high limit and at least the test report shouldn't output
"Limits Low:" for that limit. How can I change that ?

[RayFarmer]

Hi Markus,

This has been reported before and a solution from Mark can be found here.
http://exchange.ni.com/servlet/ProcessRequest?RHIVEID=101&RNAME=ViewQuestion&HOID=506500000008000000FA3E0000&ECategory=TestStand

Regards
Ray Farmer

[trout00]

Hello,
the url is obsolete, can you give me the new url for this isssue.

obsolete jump:
http://exchange.ni.com/servlet/ProcessRequest?RHIVEID=101&RNAME=ViewQuestion&HOID=506500000008000000FA3E0000&ECategory=TestStand

[RayFarmer]

Hi,

Not sure but try this http://forums.ni.com/ni/board/message?board.id=330&message.id=964&query.id=0#M964 and Mark's response.

I did a search using Limits LE within the TestStand forum.

Regards

Ray Farmer