Loading VI in TestStand

[edinsofty1]

Hi,

I am using the Temptronic ATS-710 Thermal Cooler and found a LabView driver for this.  I want to use this in a TestStand test sequence and appeared to set this up correctly using the LabView adaptor. But there seems to be a problem with the "VI Path".  It keeps looking in a location that doesn't include the VIs and never has copied to - "My Computer\........".  Any help would be appreciated.

Stuart

[~jiggawax~]

My Computer is relative to your project in the Project Path. 

It looks to me like your VI was moved relative to your project file?  Personally I don't use the Project Paths.  I haven't bought into it yet... 🙂

Make sure you can open the project in LabVIEW and it finds everything ok.

[edinsofty1]

Thanks for the reply.  What can I do to resolve this?  It all looks good in LabView and I have done a Mass Compile as well to ensure it is all fine.

[~jiggawax~ · Accepted solution]

What happens if you get rid of the project path and just browse to the VI in the VI Path?  Will the VI load then?

[Anand_Jain]

Hi, 

This is a known issue that has not yet been fixed in TestStand. As recommended by jiggawax the workaround is to configure the step to call the VI without specifying a project path. 

Regards,

Anand Jain

National Instruments

[edinsofty1]

That workaround seems to have fixed the problem.  Thanks