slow simulations with signal source

[pgo48]

This simulation runs fine but then suddenly stops! Can anyone shed any light on why this may be? 

[OStep · Accepted solution]

Hi,

I did not find that the simulation stops. I found that it significantly slows down when output of XFG1 goes low. This event appears to cause some difficulties for the simulator. Loosening the convergence tolerances helps. Go to Simulate->Interactive simulation settings->Analysis options->Customize. I suggest the following settings:

ABSTOL=1e-8

VNTOL=1e-4

RELTOL=0.01

Thanks

[Brittneytaylormich]

I have been having the same problem, suddenly slowing down at a certain time. Any suggestions on how to fix this?