Multisim and Ultiboard

cancel
Showing results for 
Search instead for 
Did you mean: 
Reply

how to wire potentiometer

Highlighted

when you flip a potentiometer horizontally the software places the slider bar above the topmost node of the potentiometer -- this makes it difficult to connect (wire) unless you dramatically zoom in.  Seems that in the next set of bug-fixes the "locus" of the slider could be changed (set relative) so that you don't have to zoom to connect.  Link below demonstrates what I am seeing:

 

 http://www.tech-diy.com/Potentiometer_how_to.gif

 

0 Kudos
Message 1 of 3
(6,304 Views)

Hi Jackinnj;

 

If you move the percentage indicator to any other place near the component you can avoid having the slider over your connection, just as the attached image demonstrates.

 

 

 

Good Luck

Francisco Arellano

National Instruments Mexico
Field Systems Engineer - Energy Segment
www.ni.com/soporte
0 Kudos
Message 2 of 3
(6,263 Views)
You're right -- the position of the slider does change -- seems that the change is activated when you click again on the schematic.
0 Kudos
Message 3 of 3
(6,254 Views)