04-20-2018 12:05 PM
Hi folks! Hope all is well. A newbie to this form. 🙂
Anyways, I am trying to simulate the circuit below in my multisim. How would I go about declaring the current source as an exponential ( as shown in the diagram) ?
Thanks for all the replies!
04-23-2018 10:34 PM
Hi friend
Concerning your question, since this input current equation is using the time as a parameter, I suggest using a transient analysis. I recommend this link.
Configuring a Transient Analysis in Multisim
http://www.ni.com/tutorial/12774/en/
Additionally, I would like to know if what you mean by u(t) is the unitary step function. I think that probably that may be more difficult to simulate, but not impossible.
04-29-2018 11:07 PM
How about the "exponential current" source in the master data base/signal current sources?