11-04-2020 03:24 AM
Hello,
I am a beginner in electronics and I start by simulating simple circuits to learn. Sorry in advance to take your time for that but thanks in advance if you could give me some tips to understand my problem.
In this simple circuirt attached, I don't able to see any charge on the capacitor on the oscilloscope. Even if the initial load of the capacitor is put to 0V in parameter, I should see a load curve, but I see immediately 9V.
Could you tell me why and/or what I did wrong ?
Regards,
Axrom
Solved! Go to Solution.
11-04-2020 03:14 PM
Hi Axrom,
In Multisim Live, Transient Analysis would produce a similar behavior if Initial conditions is set to Determine automatically. Correct simulation result can be obtained if Initial conditions is set to User defined.
Try to find and change the corresponding setting in Multisim (desktop) application. I cannot give you more details on how to do that because, currently, I don't have Multisim (desktop) application.
Best regards,
G. Goodwin
11-05-2020 04:17 AM
Hi GGoodwin,
Effectively !! Great to know that. Thanks a lot !
Regards,
Axrom