Multisim and Ultiboard

cancel
Showing results for 
Search instead for 
Did you mean: 

Strobe imput | 4094BD

Hi guys, new to forums so I hope I post everything right.

I seem to have a problem with 4094BD. From what I understood from the datasheet, once the strobe input goes 0, the register stages should be latched and no new input should go into Q0->Q7, meaning I shouldn't be able to see any change on the outputs, except Qs..

I built the circuit below, and I was surprised to see that even though strobe is '0' (or vss, or ground), I still get changes on the outputs according to my data input (again, shouldn't happen according to the datasheet).

 

The circuit:

Alon_Abr_0-1574350258598.png

 

 

Component's truth table taken from datasheet:

 

Alon_Abr_1-1574350335701.png

 

Would love if anyone knows how to fix this problem, thanks a lot.

0 Kudos
Message 1 of 1
(1,767 Views)