Something everyone can use....and it's free

[DZ001]

Hi I am new to this forum, but recently I tried to build cuircuit with LM3914 using Multisim 10 and the Spice model for this component was not available in the database.

I did a bit of the recearch and found that "Kittmaster" was able to implement it.   Is it possible to make this model available for download. 

[kittmaster]

I've never finished the model and there were some parametric issues.  I don't think it would be of any use to anyone.

[DZ001]

Thanks,

I guess I am out luck, on this one.

David

[kittmaster]

Site has been re-opened for a limited time. Personal tragedy has crossed my families doorstep, it will be open for a short time and temporarily closed again until we recover.

Thank you

Chris

[kittmaster]

Thanks, it's been a hard few months. 

I could enter you in the system, need a username.

I still use the software, but I've been using pads over the last 8 years. I think its a great idea.

I'll believe you can upload your footprints and boards into the system when your registered. Give it a shot when your account is set up, if not, I'll take a look. 

No zips, rars, exes or anything like that will be allowed to upload, but it will allow NI file extensions as I believe I have upload filters active to accept people parts for those that what to contribute.

Best,

Chris

[dbur]

"I am also searching for folks who want to lay out boards using Ultiboard and Multisim..."

What are you searching for folks to do?  I've been doing circuit designs and layouts with MS/UB for about 20 years.

[StudentGoh]

Hello, I can't seem to find kittmaster's email to get access to kittmaster. I'm trying to find a component not available in master database. The component is IC 565. Hope you could help me. Thank you.

[kittmaster]

The information you seek is all spelled out specifically from the home page and where to go to find the email. Read the article and you will understand.

[StudentGoh]

Hello,

This is the whole message at the "Legal Disclaimer" page. I don't see any email here containing "@". 

``This service is provided in the hope that it will be useful, but is not officially endorsed or supported by National Instruments^tm in any way.

We are a community of users of National Instruments^tm Circuit Design software, including Multisim/Ulticap and Ultiboard, that promote the sharing of resources with others.

While every effort will be made to ensure the integrity of the material here, we cannot guarantee that mistakes will not occur.

Use your discretion when using footprints, models, or other resources obtained here for prototyping and production applications.

This is an open community so you as the user assumes all responsibility for implementing anything gathered from this site.

Once again, please use common sense and if you have questions or doubts, ask about it on our forum.

Due to multiple bots trying to access the site for no practical reason, registration is now limited to sending me an email using the words (without spaces) Invite Me At ni.kittmaster.com. Each email will be privately verified. Thanks for your understanding.

You MUST register before the you can access or view the forum!``


Sorry if I'm actually missing something, I can't seem to find the email.

I do notice this part, but it doesn't contain the email.

``Due to multiple bots trying to access the site for no practical reason, registration is now limited to sending me an email using the words (without spaces) Invite Me At ni.kittmaster.com. Each email will be privately verified. Thanks for your understanding.``

Pressing email in the "Legal Disclaimer" page opens a window but doesn't automatically put the email. 

[StudentGoh]

StudentGoh_1-1645897943568.png

Is it actually supposed to be like this?