From Friday, April 19th (11:00 PM CDT) through Saturday, April 20th (2:00 PM CDT), 2024, ni.com will undergo system upgrades that may result in temporary service interruption.

We appreciate your patience as we improve our online experience.

Home Community Discussion Forums Most Active Software Boards Multisim and Ultiboard Topic

Multisim and Ultiboard

cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 

Simulation Error and convergence

Simulation Error and convergence

‎11-19-2019 10:02 AM

The circuit I've built is having problems and I can't figure where the problem lies. I needed an LM386 for my bottom amp but multisim didn't have the component so I made one. Could that component be the cause of my error messages?

 

Thanks,

 

 

0 Kudos
Message 1 of 2
(1,810 Views)
Reply

Re: Simulation Error and convergence

‎05-17-2020 02:33 PM

Hello Clter,

 

The simulation error was not related to "LM386" you have added.

You got error because instead of using regular DC power source you have used VCC and VEE as a source in the schematic.

Try to use power sources, references etc. properly.

 

I have replaced VCCs and VEE with DC power sources and simulation error gone.

I have attached modified project, enjoy it.

__________________________________________
The best way to thank, is to give KUDOS
0 Kudos
Message 2 of 2
(1,612 Views)
Reply