I run an interactive simulation on the circuit you sent. I got the same results as Dave@RPS.
1. Could you verify the simulation parameters you are using?
2. What happens if you create a new file and rebuild the circuit with different values? Do you get the same "zero and one" result with an interactive simulation?
2. If yes, can you build the simplest circuit and use the wattmeter to see what values if gives?
I want to determine if the problem is some settings in your simulation or if there is some corruption of your MS installation.
Anyela Vega - CLD
Could you follow this kb?: https://knowledge.ni.com/KnowledgeArticleDetails?id=kA00Z000000P8U0SAK&l=en-US
This procedure is effective when fixing corruptions of software. Make sure to run the command prompt as an administrator.