11-28-2007 04:03 AM
11-28-2007 05:17 PM
When I exported the NC-drill File recently on a project I got 2 files. One is the .drl file and the other is the labeled Drill Info.rep. This lists the tool sizes in your units of measure and the number of holes to be drilled with each one as well as the number of tools needed.
If your trying to match up your board to thier tools then you may need to have them give you a list of the sizes and then resize your pads/holes on the board to match as I do not see a way of importing a drill table.
I hope this helps some.