Multisim and Ultiboard

cancel
Showing results for 
Search instead for 
Did you mean: 

Need some help please with my circuit

Solved!
Go to solution
Highlighted

sinusoidal signal with peak-to-peak amplitude 0.2V, frequency 5kHz and offset 0.05V, and two outputs:non inverting opamp-schematic.png

A sinusoidal signal at the same frequency as the input, peak-to-peak amplitude 2.2V and offset 0.55V.
A sinusoidal signal at the same frequency as the output, peak-to-peak amplitude 1.14V, and no offset

0 Kudos
Message 1 of 7
(164 Views)
Highlighted
Solution
Accepted by topic author adi80

Hello,

 

your supplies should be VDC sources instead of sine waves. As they are, the opamp is supplied with 5V, 5kHz sine waves. Replace V1 and V2 with 5V batteries.

 

Also, your non-inverting amp gain is (1+47/10)=5.7. With an 5V input signal this will saturate your opamp and you will not see the correct output. Try with 100mV input signal in V3 with some offset if you want.

0 Kudos
Message 2 of 7
(108 Views)
Highlighted

Thank you very much. Could you guide on these VDC source. I am not an electronic student. I am just trying to learn some basic about circuits. 

0 Kudos
Message 3 of 7
(100 Views)
Highlighted

You can find the VDC source (battery) in the Sources category (DC Voltage VCC). This provides a continuous voltage as required by the amplifier supplies. The polarities you used are correct, the opamp has symmetrical supplies referenced to GND.

0 Kudos
Message 4 of 7
(89 Views)
Highlighted

Thank you very much once again. For simulation do i need to add values or it will do it automatically?

 

0 Kudos
Message 5 of 7
(83 Views)
Highlighted
Solution
Accepted by topic author adi80

Yes, you need to specify the voltages. For an ideal opamp model these can be chosen. For real opamps the supplies must comply to the device datasheet.

0 Kudos
Message 6 of 7
(78 Views)
Highlighted

Could you please help me with the calculation of the following. Thanks

A sinusoidal signal at the same frequency as the input, peak-to-peak amplitude 2.2V and offset 0.55V.
A sinusoidal signal at the same frequency as the output, peak-to-peak amplitude 1.14V, and no offset

0 Kudos
Message 7 of 7
(16 Views)