Multisim and Ultiboard

cancel
Showing results for 
Search instead for 
Did you mean: 

Multisim Convergence Error MOSFET Gate Driver

Solved!
Go to solution

Hi,

 

I don't understand why I am receiving a convergence error when attempting to simulate my H-bridge circuit after introducing the TC4420 MOSFET gate driver.

 

Specifically, I am receiving this error when I supply the gate driver with a voltage of greater than 13 V, even though the datasheet attached below mentions a maximum Vdd = 18V. Does anyone know why this is the case? 

 

Thanks

0 Kudos
Message 1 of 3
(1,270 Views)
Solution
Accepted by timbitss

I have had similar problems..I changed the RSHUNT value in Custom analysis options and got the driver to work.

bikeron_0-1615508750745.png

 

Message 2 of 3
(1,235 Views)

Thanks! I also had to reduce the error tolerances but that was the missing link.

0 Kudos
Message 3 of 3
(1,214 Views)