LabVIEW instruments built for Multisim 10.1 using 14.0

[th1622]

Hello everyone,

I am an electrical engineering student developing the analog front end circuitry for a wireless ECG device as my senior design project.  I have acquired a LabVIEW instrument providing a quality excitation signal to utilize  for simulation in Multisim; however, the instructions for installation are specific to Multisim 10.1, and I have the Multisim 14.0 student edition.  Can anyone provide any advice on how to install the VI into Multisim 14.0?  Any help would be greatly appreciated!

Thanks, 

Tim

[azp7]

Hi, I guess you mean something like this:

https://knowledge.ni.com/KnowledgeArticleDetails?id=kA00Z0000019YwGSAU&l=en-US

If don't, you can check these links

http://zone.ni.com/reference/en-XX/help/375482B-01/multisim/tutorialusingamultisimdesignviinlabview/

https://forums.ni.com/t5/Power-Electronics-Development/How-do-I-install-the-Multisim-co-simulation-p...

Now, I am not sure if this function will be available on a Student Version, you can check that here

http://www.ni.com/en-us/shop/electronic-test-instrumentation/application-software-for-electronic-tes...