From 04:00 PM CDT – 08:00 PM CDT (09:00 PM UTC – 01:00 AM UTC) Tuesday, April 16, ni.com will undergo system upgrades that may result in temporary service interruption.

We appreciate your patience as we improve our online experience.

Home Community Discussion Forums Most Active Software Boards Multisim and Ultiboard Topic

Multisim and Ultiboard

cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 

Inverting Integrator "Error: Unable to Converge"

Inverting Integrator "Error: Unable to Converge"

‎02-02-2019 09:33 AM

I am unable to figure out why this inverting integrator fails to converge. Any help would be much appreciated!

 

Inverting IntegratorInverting Integrator

0 Kudos
Message 1 of 2
(2,071 Views)
Reply

Re: Inverting Integrator "Error: Unable to Converge"

‎02-04-2019 09:24 AM

Hi,

 

Take a look at this document, I think it might solve your issue.

 

Simulation Errors in Multisim When I Run My Simulation - https://knowledge.ni.com/KnowledgeArticleDetails?id=kA00Z0000019RqVSAU&l=en-US

 

Regards,

 

Natalia Cubillo

Applications Engineering

National Instruments

 

 

0 Kudos
Message 2 of 2
(2,032 Views)
Reply