From Friday, April 19th (11:00 PM CDT) through Saturday, April 20th (2:00 PM CDT), 2024, ni.com will undergo system upgrades that may result in temporary service interruption.
We appreciate your patience as we improve our online experience.
I am making a PCB with an altered Cyclone IV with FBGA256 as a footprint.
My PCB maker does not fall below 4/4 mils (width / space) for tracks and so I set these parameters for my tracks on the PCB.
However, the autoroute function, fails to trace the lines of the FPGA, forces me to go down to even lower values. Can I change some other parameter to try to make the utotrace work well?