Multisim and Ultiboard

cancel
Showing results for 
Search instead for 
Did you mean: 
Reply

FBGA 256 ultiboard autotrace

Highlighted

FBGA 256 ultiboard autotrace

I am making a PCB with an altered Cyclone IV with FBGA256 as a footprint.

My PCB maker does not fall below 4/4 mils (width / space) for tracks and so I set these parameters for my tracks on the PCB.

However, the autoroute function, fails to trace the lines of the FPGA, forces me to go down to even lower values.
Can I change some other parameter to try to make the utotrace work well?

0 Kudos
Message 1 of 1
(112 Views)