Multisim and Ultiboard

Showing results for 
Search instead for 
Did you mean: 

Custom PC Board Layout

I am attempting to create a PCB with a cutout in the middle. You can see from the attached  PC Layout PDF there is two connectors I created, successfully transferred the design from Multisim with the rats nest and imported a DXF of the PC out line after reading this previous post

When I try to auto route I get an error "there is no board outline" How do I create a board outline so I can run the auto router.  

LeMur Technology Services, LLC
0 Kudos
Message 1 of 1