From Friday, April 19th (11:00 PM CDT) through Saturday, April 20th (2:00 PM CDT), 2024, ni.com will undergo system upgrades that may result in temporary service interruption.
We appreciate your patience as we improve our online experience.
I am attempting to create a PCB with a cutout in the middle. You can see from the attached PC Layout PDF there is two connectors I created, successfully transferred the design from Multisim with the rats nest and imported a DXF of the PC out line after reading this previous post https://forums.ni.com/t5/Multisim-and-Ultiboard/Custom-pcb-shape/m-p/425874.
When I try to auto route I get an error "there is no board outline" How do I create a board outline so I can run the auto router.
