Multisim and Ultiboard

cancel
Showing results for 
Search instead for 
Did you mean: 

Connections missing in ultiboard when transferred from multisim

Solved!
Go to solution
Highlighted
I have created a very simple schematic (test.MS14 attached) as a test to attempt to get Ultiboard working again. The reason I did this is because I cannot seem to get any schematics to transfer. What I see in Ultiboard are the parts with no connections. Furthermore the parts are locked, they can not be dragged. The project I was working on was from the first PCB I made. Now that the PCB is fully tested I saved a Rev1 set of schematics and set out to make a revised PCB. I see no DRC errors. Help?
LeMur Technology Services, LLC
0 Kudos
Message 1 of 3
(955 Views)
Solution
Accepted by topic author GleMunyan
12-20-2016 04:12 PM

Found part 1 answer. In Ultiboard Design toolbox, Information ratnest was not selected. The second problem is I cannot drag parts although I can move them using the coordinate system

LeMur Technology Services, LLC
0 Kudos
Message 2 of 3
(946 Views)
Solution
Accepted by topic author GleMunyan
12-20-2016 04:12 PM

Found a solution to my own problem again. In Ultiboard/spreadsheet view/parts right click on a part and select start placing the unplaced part. Don't know why this became a problem. 

 

LeMur Technology Services, LLC
Message 3 of 3
(938 Views)