Multisim and Ultiboard Idea Exchange

Community Browser
About Multisim and Ultiboard Idea Exchange
Do you have an idea for how to improve Multisim and Ultiboard? Submit and vote on ideas now!

  1. Browse by label or search in the Multisim and Ultiboard Idea Exchange to see if your idea has previously been submitted. If it has, be sure to vote for the idea by giving it kudos to indicate your approval!
  2. If your idea has not been submitted click the New Idea button to submit a product idea. Be sure to submit a separate post for each idea.
  3. Watch as the community gives your idea kudos and adds their input.
  4. As NI R&D considers the idea, they will change its status.
  5. Give kudos to other ideas that you would like to see in a future version of Multisim!

The Multisim and Ultiboard R&D team is committed to reviewing every idea submitted via the Multisim and Ultiboard Idea Exchange. However, we cannot guarantee the implementation of any Multisim & Ultiboard Idea Exchange submission.

cancel
Showing results for 
Search instead for 
Did you mean: 
Post an idea
0 Kudos

Sometimes a part wants non-solder mask defined pads with a certain amount of clearance, but I have only seen an option in Ultiboard to expand solder mask openings globally, and not by part.

 

It would be nice to control this on a part by part (or footprint by footprint) basis.

0 Kudos

 

If encrypted models were supported more vendors might be willing to release their models for general use.  I've heard quite often from vendors that they don't give out good models because they don't want to make it easier for someone to reverse engineer their parts.

 

See LTspice for example.  It would be great if MS could support LT encrypted models. As it is now I usually have to go back to LTspice to simulate LT devices.

 

TI also releases encrypted PSPICE models for many of their parts.  https://e2e.ti.com/support/development_tools/webench_design_center/f/234/t/36943

 

This would be great for their switching regulator models.  I'd much rather use MS to simulate, as the interface is much more modern (not like an MSDOS app from 1990).  It would also save some duplication of work.

0 Kudos

Hello, thanks for response

 

There is something about MS wire color scheme

 

Technically there are a lot of colors and tints available but practically to distinguish there are no more than 7 or 8 colors.

My suggestion is to use 2 color scheme – 1 color for wire and 2nd for strip.

In this case wire would be clearly visible with from 7*7 to 8*8 color combinations

 

 

with hope it helps

thanks a lot

Michael

0 Kudos

I would like to know how to manage anolog and logic signals on multisim.

Thank you for your answers,

 

 

0 Kudos

Hi,

 

it should be possible to expand ultiboard with user functions like the ulp's from eagle.

My intend is to generate coils or fuses automatically on the pcb copper layer (wires).

 

There should be a user interface to get the parameter and the coordinates for the placement, number of windings, frequency ...

 

Regards

Thomas