Multifunction DAQ

cancel
Showing results for 
Search instead for 
Did you mean: 

ni usb 6353

Hello,

 

I just bought a NI USB 6353 and I want to get differential voltage reading from a sensor I am building as part of a project.

When using Simulink, and using the "Analog Input" block, in Block parameters-Install new Board, I can't find my USB board. I m sure it is correctly installed, I also see it from MAX.

 

Does someone have an idea about why is this happening and if there is a solution?

 

Also, I receive this message:

 

>> out=daqhwinfo
The DAQ Legacy Interface is not supported on this platform. For more information on choosing between DAQ Legacy Interface and Session-Based
Interface, see the documentation on choosing the right interface.

To learn about using data acquisition devices on the win64 platform, see the documentation on the session-based interface.

 

Thanks a lot,

 

Stefania

0 Kudos
Message 1 of 2
(1,823 Views)

If you can see and communicate with your device in NI MAX, but not in non-NI software, you might want to try speaking with the makers of the non-NI software (:

0 Kudos
Message 2 of 2
(1,819 Views)