03-08-2006 03:17 AM
03-08-2006 06:05 AM - edited 03-08-2006 06:05 AM
Hi Curious,
I have a bit of bad news.
NI-DAQmx is only supported by LabVIEW 7.0 and later.
This means that M Series DAQ boards can not be programmed in versions of LabVIEW prior to 7.0.
http://digital.ni.com/public.nsf/allkb/D71534B93E1FF62D86256F70005A040C read this link.
Well, if you move on to labVIEW 7.0 or higher, you can have both traditional DAQ and DAQmx supported devices running on same PXI system.( however, do read this link http://digital.ni.com/public.nsf/allkb/F2DFF1D7B50A0820862570C100602EA8 before that, it will help you choose DAQ version if you shift to higher version of LabVIEW)
E series has support for both traditional DAQ and DAQ mx. so no bother which version of NI DAQ driver you use.
M Series however, is only supported By DAQmx.
so these are your options
Hope this helps
further doubts? do get back
Regards
Dev
Message Edited by devchander on 03-08-2006 06:06 AM