cDAQ 9219 bridge calibration error

[ahunter10]

I am trying to measure 4 full-bridge load cells with a 9219 analog input card.

The load cells are 2 mV/V, 350 ohm.  

I am using the DAQ assistant. 

When I try to calibrate a channel on the card (offset nulling) in the DAQ assistant, I get the following error:

Error -200077

Value: SampQuant.SampPerChan

Requested Vaue: 1

Valid Value begins at: 2

It appears that the calibration dialog is not requesting data properly from this card. Any ideas for solving this?

[chaka123]

Hi ahunter10

Seems that the problem that you are specifying a value that is out of the calibration range. This Knowledge Base article shows how to change the calibration range.  

Regards