Multifunction DAQ

cancel
Showing results for 
Search instead for 
Did you mean: 

cDAQ-9184 problem. Modules in uknown state?

Hi

 

I'm using Measurement and Automation explorer to config tasks for my cDAQ-9184 ethernet device. Everything works ok. I can load and run tasks from c# .net using DAQmx.

 

But, if the PC (running windows 7) has gone to sleep and I "wake" it up and try to run any task on the cDAQ-9184 I get an exception.

Also, when I start MAX and look at the card it seemes that the modules are disconnected. See screenshot.

Modules in uknown state?!'

 

If I perform a self-test. The modules will go "online" again after some time.

 

I've seen the same behaviour on a different 9184 system. I also tried the latest firmware 1.5.1

 

Do you have any ideas? Is this the normal behaviour? Are the modules in some sort of sleep-mode? 🙂

 

/Mats

 

0 Kudos
Message 1 of 4
(2,576 Views)

Oh, and by the way. The exception I get is the following. 

Exception

0 Kudos
Message 2 of 4
(2,573 Views)

Hi DevAutoit-

 

I suspect that you're running into the behavior that I describe in this post.  Basically, suspending the system is observed as a loss in a connection between the chassis and your host PC, so a Device Reset (or similar) operation is required on the chassis object to re-establish the connection between the two.  Hopefully this is a fairly painless addition to your program that can add a lot of reliability improvement.

 

 

Hopefully this helps-

Tom W
National Instruments
0 Kudos
Message 3 of 4
(2,565 Views)

Hello

 

Doing a Self-test in the beginning of application solves the problem. But we didn't see this problem using a cDAQ9181, in that application we created tasks programatically and verified them instead of Loading tasks.

Thx for your answer.

0 Kudos
Message 4 of 4
(2,551 Views)