Hello every one,
I would like to acquire a tension with the NI card.
Currently, I just have the LABVIEW software and I would like to do a simulation without the hardware for the moment.
I was able to visualize the tension on a scrolling graph and I am stuck on the points below:
-TRIGGER and PRE-TRIGGER
-Timebased (ms/Div) and V/DIV.
Below is my program and I don't know why the trigger and pre-trigger don't work?
Can someone give me a hand, please?
Simulated devices does not simulate triggering.
You will find in this documents the functions not supported by simulation :
Have a good day
National Instruments France
Tanks you for your answer.
I worke to the NI-PXIe-6366 an d i would like to use all input anolgique.
why I did it like that. I'm a beginner from Labview.