If you are using LabVIEW and have NI-DAQ 6.5.x or later, you can read up on
the usable parameters in the Route Signal VI.
I hope that helps.
--
| Ken Sadahiro (Ken.Sadahiro@ni.com)
| Sr. Software Engineer, User Advocate
| Systems & Architectures: Applications Group
+----+-------------------------------------------
| National Instruments Corporation
| 11500-A North MoPac Expressway
| Austin, Texas 78759-3504 USA
| Tel: +1.512.683.8806
| Fax: +1.512.683.8641
| URL: http://www.ni.com/
Grant Griffith wrote in message
news:38219e90@newsgroups.ni.com...
>
> Hello All,
>
> We are using a AT-MIO-16XE-50 board and are trying to get the SCANCLK
> lines to function properly. The documents say that it is softwa
re
enabled,
> however I can not find any way to enable it or turn it on.
>
> Can someone give me an idea or at least where to find this information?
>
> Thanks,
> Grant