From Friday, April 19th (11:00 PM CDT) through Saturday, April 20th (2:00 PM CDT), 2024, ni.com will undergo system upgrades that may result in temporary service interruption.

We appreciate your patience as we improve our online experience.

Home Community Discussion Forums Most Active Hardware Boards Multifunction DAQ Topic

Multifunction DAQ

cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 

NI 9381 sine wave generation using FPGA and oscilloscope

NI 9381 sine wave generation using FPGA and oscilloscope

‎05-19-2016 09:44 AM

hello I am trying to Generate a sine wave and send it to the output pin of NI 9381 Multifuction I/O..

 

The generation of sine wave is perfec but I could not read it on oscilloscope properly.... I dont know the reason....

 

 

I have attached the VI .....in that VI block diagram the signal value is in I16 variable and output to module4 AO7.......

0 Kudos
Message 1 of 3
(3,248 Views)
Reply

Re: NI 9381 sine wave generation using FPGA and oscilloscope

‎05-19-2016 10:42 AM

What are your oscilloscope settings?  Timebase? Channel Impedence?  Channel voltage range?

GCentral
There are only two ways to tell somebody thanks: Kudos and Marked Solutions
Unofficial Forum Rules and Guidelines
"Not that we are sufficient in ourselves to claim anything as coming from us, but our sufficiency is from God" - 2 Corinthians 3:5
Message 2 of 3
(3,243 Views)
Reply

Re: NI 9381 sine wave generation using FPGA and oscilloscope

‎05-19-2016 01:44 PM

Everything is correct that side.... Actually my college is doing oscilloscope settings and he is expert in taht.... so no worries....

0 Kudos
Message 3 of 3
(3,238 Views)
Reply