Multifunction DAQ

cancel
Showing results for 
Search instead for 
Did you mean: 

How to simultaneously Read scope 0 and scope 1 of elvis ii?

Dear all:

  I am a user of LabVIEW 2010. Recently, I have downloaded the lockin start up kit. I want to use ELVIS for the signal input. I want to input the data signal and reference signal using scope 0 and 1. But in the front panel of the demo lockin program, I only can assign 1 scope for input. I have see the back panel of the program, the signal from the DAQmx is 2d array. Therefore, all scope should be assigned. How I can assign both scopesHo in front panel?

0 Kudos
Message 1 of 3
(3,755 Views)

Hi nieekfbm,

 

Unfortunately the lock-in startup kit is not officially supported by NI anymore but I'm hopeful that the forum users will be able to relate to your question. Are you able to post a screenshot of the interface and where your issue is occuring?

David H.
National Instruments
0 Kudos
Message 2 of 3
(3,724 Views)

I find that elvis is support the simultaneously reading of scope 0 and scope 1

Thank

0 Kudos
Message 3 of 3
(3,713 Views)