DAQmx error for NI USB-6008

[pda daq]

Hi All,
I hope someone can help me.

I got a problem with DAQmx and NI USB-6008. I attach the error message.
FYI, I am using NI USB-6008 to read the output voltage from a temperature sensor LM35CZ.
When the system is used to read the voltage with an update period of 1 sec, the system does not have a problem.
But when the system is used to read the voltage with an update period of more than 1 second error message appears..

DAQmx I use is version 8.9.5

Regards.

Ajun A.

[enderWiggin10]

Hi pda daq,

This error indicates that you are most likely sampling faster on your board that what you are retrieving form your onboard FIFO buffer in software.  Here is a great KnowledgeBase article that discusses the error in more detail.  Please take a look at some of the suggested ways to correct this error.  Also, looking at your setup, you just have a DAQ Assistant with some signal processing.  If you remove the processing VI from your block diagram, do you still get the same error?

Best,

[pda daq]

I use my USB-6008 for application with PDA..but I got error. my application didn't read analog input from sensor. anyone can help me??

[enderWiggin10]

Hi pda daq:

It is appears that you have already addressed this issue is this forum.  Let's proceed by pursuing the issue in only one forum.  Here are a few links to take a look at as well:

http://forums.ni.com/t5/LabVIEW/Unable-to-compile-PDA-application-for-USB-6008/m-p/830159

Also, you will need to use DAQmx Base most likely for the PDA module, found here.  Also, we do have the PDA module, found here.

Best,