From Friday, April 19th (11:00 PM CDT) through Saturday, April 20th (2:00 PM CDT), 2024, ni.com will undergo system upgrades that may result in temporary service interruption.

We appreciate your patience as we improve our online experience.

Home Community Discussion Forums Most Active Hardware Boards Multifunction DAQ Topic

Multifunction DAQ

cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 

DAQCard-AI-16E-4 Config Utility vs VB command set.

DAQCard-AI-16E-4 Config Utility vs VB command set.

‎01-25-2000 01:06 PM

The National Instruments Config Utility allows me to select the mode of the
card for analog input. I can choose differential, single-ended referenced
or single-ended non-referenced. Can I set these parameters using VB
commands or does the user need to make sure the configuration is correct in
the Config Utility manually?
0 Kudos
Message 1 of 1
(3,161 Views)
Reply