03-29-2022 02:12 AM - edited 03-29-2022 02:20 AM
I wanted to find a DAQ system for following instrument. It has a 9 pole D-Sub output connector with 0-10V range. Sampling rate can be 100S/s or less so not a big problem. But on NI website I am only finding 2 D-Sub connection DAQs in PCI-6221 and PCI-6154. The latter is out of my budget which is less than $1000, so leaves only with one option. However, I cannot find PCI-6221 data sheet so I need help in:
1) Getting PCI-6221 datasheet
2) Is there any other DAQ/configuration would recommend that can be better in terms of maybe I can use other sensors also with it not just limited to this instrument (I can buy some sort of adapter for this instrument to connect to DAQ) that way I have some options to consider. Ideally I want the connection from DAQ to my computer to be USB not PCI.
03-29-2022 06:49 AM
Don't be fixated on the connector. You can make your own cable, which those using this with a PLC will do.
You could probably go with a low end DAQ such as a USB-6000, which goes for ~$200.
03-29-2022 08:16 AM
If all that you require are these,
I will also recommend the low-cost USB-600x series same as crossrulz and create a custom cable
04-01-2022 01:07 AM
Ok I see the USB have screw terminals so I would have to do a DSub to screw terminal adapter?
04-01-2022 06:18 AM
@vepa wrote:
Ok I see the USB have screw terminals so I would have to do a DSub to screw terminal adapter?
You just need a DB-9 connector (like this one) and some wire.
04-08-2022 10:56 PM
@vepa wrote:
Ok I see the USB have screw terminals so I would have to do a DSub to screw terminal adapter?
Since you keep looking for a readily available adapter despite the recommendation to create a custom one, I would assume you're not from an electrical background?