Can not configure PAd1200 -parallel

[sue]

I have a Daq Pad 1200 -parallel from an old project. when i run the test panel which comes with the daq driver, i got following error: the device is not responding to the selected base address. I check the BIO on the PC, the setting matchs. I also checked the cable connection and etc as directed on the web. please let me know what I missed.

Also, i would like to know whether DAQ driver Rev6.7 supports Pad1200-parallel. I tried the driver on a different pc, seems it is not support the parallel pad1200.

[Filipe A.]

Hello;

The DaqPad you have is supported by NI-DAQ version 6.7.
At this point, it's hard to figure what might be wrong, however, you can follow the steps listed at
http://www.ni.com/support/install/parallel/default.htm
for parallel DAQ devices installation.

Hope this helps.
Filipe A.
Applications Engineer
National Instruments