Multifunction DAQ

cancel
Showing results for 
Search instead for 
Did you mean: 

Acquisition trigger start and stop - any new methods for DAQmx 8 and M series devices?

There hasn't been any good way that I've seen to start an acquisition on a digital edge and then stop the acquisition on the opposite edge of the same digital line. Has DAQmx 8 and/or M series devices changed that?
 
George
0 Kudos
Message 1 of 4
(3,069 Views)
Actually, there has been a way to do this since DAQmx 7.0.  Although the hardware doesn't support a true stop trigger, you can use a reference trigger to effectively do what you want with some minor caveats.  Check out this thread and see if this solution will work for you.
0 Kudos
Message 2 of 4
(3,059 Views)

Thanks. I did see that and actually have it working. Even though the explanation is good I'm still a little fuzzy on how it actually works. I was just wondering if there was anything new to allow you to do it in a more straightforward manner.

George

0 Kudos
Message 3 of 4
(3,055 Views)
Hi George,

This KnowledgeBase article goes into details about how this works.  At the moment, there aren't any new features that allow you to implement a stop trigger differently though.

Thaison V
Message 4 of 4
(3,044 Views)