Hi!
I´m useing a PCI-MIO-16E-4 daq-board
with LabVIEW, NI-DAQ 6.8 and WinNT service pack 6.
I also have connected a SCXI-1000 chassi with one switch module (SCXI-1160)
in it, that my DAQ-board controls.
The problem is that I get this warning:
"Warning 10694 occurred at AI Control.
Possible reasons:
NI-DAQ LV: The scan rate is above the maximum or below the minimum for the
hardware, gains, and filters used."
when I´m acquire data at the maximum scan rate for one channel 500kS/s. I´m
only useing one channel for acquisition.
Does anyone know how to fix this?