Oriental Motor : ARD-KD & Labview driver

[Minikisscool]

Hi,

I have a stepper motor (ARM69AK) and controller ARD-KD.

Does anyone have a Labview driver for this controller or sample code.

I want to use RS485 to control it.
I downloaded and installed modbus Labview Library.

thanks in advance

[SKYDUBIN]

I have the same Question : )   I have looked for the Labview library for this motor driver for a while, bus got nothing : (

[Minikisscool]

Hi Skydubin,

I didn't found any driver for Oriental Motor.
Finally, I developped my program with Modbus driver from DSC module

read, write and the adress of the register...

[SKYDUBIN]

Hi Minikisscool,

it is great !! You have succesafully developped you program . : )

You said you developped your program with Modbus driver from DSC module. 

 http://www.ni.com/labview/labviewdsc/d/      is it ?

You have download this LabVIEW DSC to develop you programm? 

Or you just use the modbus Labview Library? Last week i get the Motor and Driver and i am really new in Labview : ( 

I would be very thankful if you could send me the Labview Programm Code : ) 

[SKYDUBIN]

My Email : rising1sun1@hotmail.com

thanks in advance

[Minikisscool]

in fact, I found 3 version of Modbus Library

MODBUS Library for LabVIEW Version 1.21
http://www.ni.com/example/29756/en/

LabVIEW Modbus API v1.1.3.32

https://decibel.ni.com/content/docs/DOC-30140

MODBUS included in DSC module for LV2014
http://zone.ni.com/reference/en-XX/help/370622M-01/lvmve/choose_modbus_ioserver_vi/

I already made a development with 1.21 from NI.

My program works with RS485 through COM port. (Computer to device)

I don't devellop a full correct driver, but I have a code witch read a lot of usefull register and an other with Read / Write

[SKYDUBIN]

thanks a lot for your useful information : )   i think i can work further on it.

[Minikisscool]

Hi, 

I attached 3 files

1 for NI modbus driver and 2 for DSC driver

I hope, it will help you. 
For me, it was not so easy to works with material from Oriental Motor. It should be the last time.
I don't recommend theses produts, No Labview driver, no support (phone, mail or forum)
 

[Minikisscool]

Two others usefull program

[SKYDUBIN]

Thank you very much. 

And you are absolutly right !!  It is really hard to work with Oriental Motor. : (