Motion Control and Motor Drives

cancel
Showing results for 
Search instead for 
Did you mean: 

How to read out a RPM signal in labview using UMI 7764 and PCI 7330

Highlighted

Hi

 

I have a problem getting a encoder signal into a labview program. The encoder is connected to a UMI 7764 motion device. This device is connected to a PC trough a PCI 7330. I heard rumors that I can't have more than two axis on a PCI 7330. But can I have more than 2 encoders on it?

 

The big problem is that I am new to the motion system and I don't know where to begin.

I'm going to finish a uncompleted system, but when I look at the VI, I get nervous. So you are my last hope.

I have taken screen captures of the VI and uploaded it.

My task is to implement a new encoder signal to the already-made VI.

Question is:

How do I add and read out a RPM signal from a new encoder?

 

 

VI download:

http://www.mediafire.com/?k1ckbozeppffv1z

 

 

 

 

 

Best regards

Henrik Myhre

 

 

 

 

0 Kudos
Message 1 of 1
(3,885 Views)