04-25-2017 11:17 PM
I am using a Linmot Linear Motor/Actuator with a B1100PP drive. It is currently being controlled by a proprietary Linmot software called Linmot Talk. I would want to create a Labview VI which allows me to control the motor using that instead of the Linmot Talk software. The specific inputs which I would want to control are the current, voltage, motion profile, position, encoder feedback, gains, etc. Can I get some initial idea on how to approach this problem, for example, regarding the types of modules to be used for interfacing, example labview VIs etc.
04-27-2017 09:50 AM
Hi beheradipankar1993,
That would depend on different factors:
- What kind of signal/communication does the B1100PP drive accept?
- What does the rest of your system look like? Are you using a cRIO and drive interface module?
- Are you using NI-SoftMotion?
Lastly, there are LabVIEW SoftMotion motor control examples in LabVIEW's Example Finder. I would recommend looking into those as examples, but I would focus on the system set up first.
Angela L.
National Instruments
11-14-2019 03:26 AM
Hi
as I am looking into the same issue: did you get it working? Thanks for an update.
MiC