Home Community Discussion Forums Most Active Software Boards Measurement Studio for VC++ Topic

Measurement Studio for VC++

cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 

Using Borland C++ in a vi to use a JR Kerr steper motor controler

Using Borland C++ in a vi to use a JR Kerr steper motor controler

‎03-15-2003 02:29 PM

I am trying to develop a vi to move a pitot tube with a steper. The control hardware is a JR Kerr Pic-Step board. The software is borland C++
Thanks!!
0 Kudos
Message 1 of 2
(2,595 Views)
Reply

Re: Using Borland C++ in a vi to use a JR Kerr steper motor controler

‎04-17-2003 10:44 AM

vi...are you using LabView? "the software is C++" do you mean the drivers for the PIC-Step board? Have you established any kind of communication? What part of the process is fighting you right now?
Grant M. Johnson
Project Engineer
LECO Corporation
0 Kudos
Message 2 of 2
(2,595 Views)
Reply