Machine Vision

cancel
Showing results for 
Search instead for 
Did you mean: 

two cameras wiht a same name in Vision Builder AI

Hi everybody,

how can i two cameras whit a same name in Vision Builder AI identify like device 1 and device 2?
my problem is that i connect the two cameras but the VBAI identifies only one


thanks

Jois
0 Kudos
Message 1 of 7
(3,511 Views)

Hi Jois

 

 

Check that both cameras are  detected :

 

 

1 -  in the Device Manager

2 -  in MAX

 

 

 

Doc-Doc
http://www.machinevision.ch
http://visionindustrielle.ch
Please take time to rate this answer
0 Kudos
Message 2 of 7
(3,493 Views)
0 Kudos
Message 3 of 7
(3,491 Views)
Well this link only says that you can only work with 1 picture at a time, it does not say you cannot configure and snap pictures from 2 cameras.
Doc-Doc
http://www.machinevision.ch
http://visionindustrielle.ch
Please take time to rate this answer
0 Kudos
Message 4 of 7
(3,487 Views)

 

Hi Doc-Doc,

thanks for your reply
in MAX there is only one camera und  i have two USB ports and both normally work, but i can only one USB port use

i connect the camera in the other and don´t works . Maybe i muss configure the other port ?

 

 thanks for your Help

 

 

Jois

0 Kudos
Message 5 of 7
(3,486 Views)
Maybe you shoud try to use a usb hub if you have only 1 good usb port.
Doc-Doc
http://www.machinevision.ch
http://visionindustrielle.ch
Please take time to rate this answer
0 Kudos
Message 6 of 7
(3,480 Views)

From your posts in a bunch of other threads, it sounds like you are using IDS uEye cameras. Their DirectShow drivers show by default a single (virtual) device regardless of how many cameras (even 0) you have connected. You'd have to consult with them as to how to get their drivers to add more than one DirectShow interface.

 

Eric 

0 Kudos
Message 7 of 7
(3,455 Views)