Machine Vision

cancel
Showing results for 
Search instead for 
Did you mean: 

Extract edge points from Find Circular Edge

Solved!
Go to solution

I am trying to extract the identified edge points while performing a Circular Edge detection using LabVIEW Vision. 

Using the Vision Assistant, I can see these values however there is no way to export them. I can only export the Results. 

image.png

When I export the script to LabVIEW, I can get the identified circle but not the full set of points. 

Is there a way to get these values from within LabVIEW?

Thanks,

Greg

0 Kudos
Message 1 of 3
(2,596 Views)
Solution
Accepted by topic author GregPayne

I think you could use IMAQ Spoke to return an array of the detected points. If you give it the same settings as IMAQ Find Circular Edge I would expect them return the same points.

0 Kudos
Message 2 of 3
(2,578 Views)

From an initial look, that should be what I am looking. Will give a bit more testing tomorrow when I'm back in the office.

 

Thanks, 

Greg

0 Kudos
Message 3 of 3
(2,576 Views)