03-15-2018 01:21 PM
Redhat 5.1.3 was loaded, followed by NI-DAQmxbase 3.7. lsdaq properly describes the DAQ Card as PCI-6221. A driver that we build for our RF SIM requires the full NILIB, so we also loaded NI-DAQmx (8.0.1) on top of 3.7. This loaded without error, however, per Knowledge Article (kA00Z0000019MCVSA2) we did comment out any reference to the PCI-6221. Neither nidatalogger nor mxbaseconfig allow me to test the DAQ board. They come up on screen but seem to be hard-coded and provide generic data. Some areas are greyed out and won't let me create a task. I also tried the AI example for acquireNScans, but it too comes up with generic data. By generic, I mean that I short out the AI1 input to AIGND and the data onscreen continues to come up with data near -10V or +10V, never around 0V. I'm looking for a simple means to verify just one Analog Input. Any feedback is appreciated.
05-15-2018 11:54 PM
You're using a 15 years old distro ? Seriously ?