10-12-2014 01:29 AM
Hello
can u help me?
what is the process to monitoring and control some reservoir and pupm?
I have some water tank and some pump. I want monitor and control tanks level but Im new in labview.
what tools i need?
what is the process of camputer until hardware?
can u give me step by step process?
10-12-2014 02:33 AM
Take a look at this thread, it may be helpful: monitoring unknown tank level and control
10-12-2014 02:42 AM - edited 10-12-2014 02:46 AM
tnx chembo
that is my topic too.
my new question is different
best regards
10-12-2014 09:21 AM
Step by step process-
1. Learn LabVIEW using the freely available courses. Read through the LabVIEW help.
2. Come back here and ask for the next step.
Pointless trying to jump into a project when you're not even familiar with LabVIEW. This may not be the answer you want, but it's the most helpful answer in terms of bringing you long-term success.
10-12-2014 09:39 AM
If you don't know what sensors you have or how to program them if you do, I'd either follow toecutter's advice or pay someone to write a program. You'll never find the answer otherwise
10-12-2014 01:20 PM
10-12-2014 03:17 PM
@GerdW wrote:
Hi behzad,
you really should mention your very related older thread…
Wasn't it being linked in Message 2 and him acknowledging it sufficient?
10-14-2014 12:43 AM - edited 10-14-2014 12:52 AM
Hi
@GerdW wrote:
Hi behzad,
you really should mention your very related older thread…
In that topic I try to find a way to use of wizard for input data. however I wrote all process. but in this topic, I'm trying to find
operational way to implement all of my project.
@natasftw wrote:
Wasn't it being linked in Message 2 and him acknowledging it sufficient?
actually, I need details of process. I know I have around 16 digital input/output, I have around 10 analog input. I want contol pump activity. my sensor are ultrasound level meter,pressure gauge,thermometer and like these.
Best regards
10-14-2014 01:14 AM
Hi behzad,
you need to learn the basics of control systems. Wikipedia is a good source…
LabVIEW comes with a lot of control algorithms. PID is included in the current version, in older ones you need to install (and buy) the PID&Fuzzy toolkit…
10-14-2014 02:23 AM
Hi GerdW
tnx.
I'm acquaint with the basics of control systems. I want use of an optimization alogorithm in mathscript node instead of PID in this step.
I want input an excel file and some manual set as Input of system to exe program. and then start work. can u explain dedtails from program, interface, and hardware connections? is necessary any toolkit yet?