what is the process to monitoring and control some reservoir and pupm?

[behzad1]

Hello

can u help me?

what is the process to monitoring and control some reservoir and pupm?

I have some water tank and some pump. I want monitor and control tanks level but Im new in labview.

what tools i need?

what is the process of camputer until hardware?

can u give me step by step process?

[chembo]

Take a look at this thread, it may be helpful: monitoring unknown tank level and control

[behzad1]

tnx chembo

that is my topic too.

my new question is different

best regards

[ToeCutter]

Step by step process-

1. Learn LabVIEW using the freely available courses. Read through the LabVIEW help.

2. Come back here and ask for the next step.

Pointless trying to jump into a project when you're not even familiar with LabVIEW. This may not be the answer you want, but it's the most helpful answer in terms of bringing you long-term success.

[natasftw]

If you don't know what sensors you have or how to program them if you do, I'd either follow toecutter's advice or pay someone to write a program.  You'll never find the answer otherwise

[GerdW]

Hi behzad,

you really should mention your very related older thread…

[natasftw]

---

@GerdW wrote:

Hi behzad,

you really should mention your very related older thread…

---

Wasn't it being linked in Message 2 and him acknowledging it sufficient?

[behzad1]

Hi

---

@GerdW wrote:

Hi behzad,

you really should mention your very related older thread…

---

In that topic I try to find a way to use of wizard for input data. however I wrote all process. but in this topic,  I'm trying to find

operational way to implement all of my project.

---

@natasftw wrote:

Wasn't it being linked in Message 2 and him acknowledging it sufficient?

---

actually, I need details of process. I know I have around 16 digital input/output, I have around 10 analog input. I want contol pump activity. my sensor are ultrasound level meter,pressure gauge,thermometer and like these.

Best regards

[GerdW]

Hi behzad,

you need to learn the basics of control systems. Wikipedia is a good source…

LabVIEW comes with a lot of control algorithms. PID is included in the current version, in older ones you need to install (and buy) the PID&Fuzzy toolkit…

[behzad1]

Hi GerdW

tnx.

I'm acquaint with the basics of control systems. I want use of an optimization alogorithm in mathscript node instead of PID in this step.

I want input an excel file and some manual set as Input of system to exe program. and then start work. can u explain dedtails from program, interface, and hardware connections? is necessary any toolkit yet?