vision

[navaneetha]

I'm new to lab view i have a problem in connecting imaging source camera in lab view. I tried to connect camera from the instructions provided in www.ni.com there is a small issue in Devices and interfaces here i attached the screen shots. Kindly do the needful.   

[RavensFan]

This message board is for threads discussing the operation of the forums themselves.

You need to post your question in the LabVIEW forum, or send a message to the moderator to have it moved there.

[crossrulz]

I already asked the moderator to move this thread.

[falkpl · Accepted solution]

Do you have image acquisition software installed (imaq, imaqdx) , what type of camera have you plugged in (gigE, firewire, usb, cameralink.....). 

what have you done so far?

[navaneetha]

Hi Paul Falkenstein

Thanks for your reply. 

I have installed NI-IMAQ 4.7.3, I'm using Imaging source USB camera what has to be done next?

Thanks

R Rakesh Reddy

[falkpl]

You need imaqDX installed for usb cameras, IMAQ is for cameralink cards.  Make sure under software you have installed imaqdx drivers.

[wangxuwang]

If  you want to open and operate the image,your computer must have been installed the vision model successfully.