LabVIEW

cancel
Showing results for 
Search instead for 
Did you mean: 

usb 6211 and LabView - good for IV characteristic aquisition?

Hi there,

I pre-emptively declare my lowest level in using LabView and all the annex tools, so my question won't result too silly.

 

I need to automatically acquire the IV characteristics for 4 solar devices, so I am thinking about connecting them to the USB 6211 in order to switch from one device to another one.

My question is: can I use a LabView Program in order to simulate the Voltage signal to apply (range c.ca -1 to +1 V), and then collect the relative current?

 

If so, how??

 

Many thanks in advance for any sort of help.

 

Laura

0 Kudos
Message 1 of 5
(590 Views)

http://zone.ni.com/devzone/cda/epd/p/id/5918

http://zone.ni.com/devzone/cda/tut/p/id/7229

 

LabVIEW has a toolkit available for this.  It uses an SMU card but you could simulate that with your 6211 and a current sensing resistor.

LabVIEW 8.5.1 - 2018 Pro Dev
0 Kudos
Message 2 of 5
(580 Views)

There are no silly questions.

There are just silly moods to feel that so Smiley Happy

 

0 Kudos
Message 3 of 5
(562 Views)

@NIquist wrote:

http://zone.ni.com/devzone/cda/epd/p/id/5918

http://zone.ni.com/devzone/cda/tut/p/id/7229

 

LabVIEW has a toolkit available for this.  It uses an SMU card but you could simulate that with your 6211 and a current sensing resistor.


Thank you so much for your infos!

0 Kudos
Message 4 of 5
(555 Views)

@DinosaurBarBQue wrote:

There are no silly questions.

There are just silly moods to feel that so Smiley Happy

 


You are right,but you know.. sometimes the doubt is still there..!! Thanks

0 Kudos
Message 5 of 5
(554 Views)