LabVIEW

cancel
Showing results for 
Search instead for 
Did you mean: 

time step error

HELLO SIR,

 

I am doing my M.E.,project in  power converters area.i have successfully designed my converter in multisim.For designing a PI controller i had linked my multisim model with labview.As per my design my switching frequency is 10KHZ.In multisim,my maximum step size is 1E-005.but in labview my minimum step size is 1E-005.so i am getting time step error.But when i run the simulation with frequency 20KHZ my desired output is reached without error.Also for duty cycle 0.5 i am not getting on time and off time equal.I have no idea how to correct my problem .Can u pls get me the solution?i have attached my snap shots over here.

0 Kudos
Message 1 of 1
(2,007 Views)