LabVIEW

cancel
Showing results for 
Search instead for 
Did you mean: 

the occupational ratio of CPU goes up to 100% when tested

Highlighted

Hey, this is a new learner of Labview8.6 and I had a question about my program. What I did is to pick data from certain lines in a txt file. the function is achieved, but unfortunatelly, the CPU Usage will go directly to 100% after I excuted it. this is not acceptable and is there anyone here had this problems before? and can u give some suggestions?

 

Cheers

0 Kudos
Message 1 of 4
(1,037 Views)
Highlighted

hello,

 

can you post the piece of code wich poses probleme....

 

regards

 

Tinnitus

 

 

 

CLAD / Labview 2011, Win Xp
------------------------------------------------------
Mission d'une semaine- à plusieurs mois laissez moi un MP...
RP et Midi-pyrénées .Km+++ si possibilité de télétravail

Kudos always accepted / Les petits clicks jaunes sont toujours appréciés
Don't forget to valid a good answer / pensez à valider une réponse correcte
Message 2 of 4
(1,014 Views)
Highlighted

 

 Using simple while loop???

 

 try putting some delay. you can achieve this using  "wait (ms)" function.

 

 

Anil Punnam
CLD
LV 2012, TestStand 4.2..........
0 Kudos
Message 3 of 4
(1,014 Views)
Highlighted
hey, thanks for replying, I got it solven by erasing some useless icons and now it's stable on 20%
0 Kudos
Message 4 of 4
(969 Views)